Abstract
Several emulsions consisting of biomass pyrolysis oil (bio-oil) in diesel fuel were produced and analyzed for stability over time. An ultrasonic probe was used to generate microscopic droplets of bio-oil suspended in diesel fuel, and this emulsion was stabilized using surfactant chemicals. The most stable emulsion was produced using a polyethylene glycol dipolyhydroxystearate (PEG-DPHS) surfactant, with a hydrophilic–lipophilic balance (HLB) number of 4.75 and a 32:8:1 ratio of diesel to bio-oil to surfactant, i.e., 20% utilization of bio-oil. This emulsion consisted of uniformly sized droplets with an average diameter of 0.48 μm, with no observed coalescence of droplets after 1 week. If left undisturbed, these droplets would slowly settle to the bottom of the mixture at a rate of only 2.4 mm/day, but this settling can be eliminated with slight mechanical agitation. This level of stability facilitates utilization of 20 wt % raw bio-oil in diesel as a renewable liquid fuel for spray combustion without the ...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
