Maxillary Obturator Prosthesis Made with Polyetherketoneketone Using Optical Impression and CAD/CAM System.

Abstract

This report describes the case of a 68-year-old man who visited our department complaining of poor denture retention and difficulty masticating due to damage to the retainer of a maxillary obturator. The patient had never been satisfied with the fit of this prosthesis, which had been placed two years earlier. The obturator and the mucosal surface of the denture base were incompatible, which had caused the retainer to detach. The maxillary defect was categorized as H3S0D0T0 according to the HS classification. The diagnosis was a masticatory disorder due to a damaged retainer and an incompatible denture base. Optical impressions and occlusal records were taken and a maxillary obturator fabricated using a CAD/CAM system. Dental CAD software was used to design and complete the tooth arrangement. The CAM system was used to mill a polyetherketoneketone disc based on the obtained data and composite resin used to face the teeth and gingiva. The maxillary obturator was placed after only three visits, spanning from impression taking to denture completion. The use of digital data allowed the time to denture completion to be shortened in addition to the number of hospital visits to be reduced. Compared to conventional impression taking, optical impressions also prevent discomfort, decreasing stress for the patient.