Abstract

The paper considers mathematical modeling and optimization of the design of a single-phase high-speed flux reversal motor for an angle grinder. The optimization criterion and the selection of the optimization algorithm are described. The optimization target parameter is the motor efficiency when operating at different loads while limiting the mass of permanent magnets that can be demagnetized. Calculations show that after optimization, it was possible to significantly increase the motor efficiency and reduce the rotor diameter.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.