Abstract
Ultrasonic treatment (UST) was studied in this work to improve the quality of the cast ingots as well as to control the solidification structure evolution. Ultrasonically induced cavitation consists of the formation of small cavities (bubbles) in the molten metal followed by their growth, pulsation, and collapse. These cavities are created by the tensile stresses that are produced by acoustic waves in the rarefaction phase. The pressure for nucleation of the bubbles (e.g., cavitation threshold pressure) may decrease with increasing the amount of dissolved gases and especially with the amount of inclusions in the melt. Modeling and simulation of casting solidification of alloys with UST requires complex multiscale computations, from computational fluid dynamics (CFD) macroscopic modeling through mesoscopic to microscopic modeling, as well as strategies to link various length-scales emerged in modeling of microstructural evolution. The developed UST modeling approach is based on the numerical solution of the Lilley model (that is founded on Lighthills’s acoustic analogy), fluid flow, heat transfer equations, and mesoscopic modeling of the grain structure. The CFD analysis tool is capable of modeling acoustic streaming and ultrasonic cavitation. It is used in this work to study ingot solidification under the presence of ultrasound. The UST model was applied to low-temperature alloys including Al- and Mg-based alloys. Although the predicted ultrasonic cavitation region is relatively small, the acoustic streaming is strong and, thus, the created/survived bubbles/nuclei are transported into the bulk liquid quickly. The predicted grain size under UST condition is at least one order of magnitude lower than that without UST.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have