Abstract
The single-belt process is a new route to produce steel strips, in which the single-belt caster is directly connected with hot mills. This process should be able to roll strip with thickness 1 mm or below. In hot rolling of the ultra thin strip there are many limitations which are represented by the finishing rolling temperature of the strip, the oxidation of the strip, the overheat of the roll and the maximum rolling speed. In the present paper the possibility of hot rolling ultra thin strip in the single-belt process was investigated. On the basis of mechanical/thermal/metallurgical behavior of the strip a mathematical model of draft schedule was proposed. In terms of different criteria the draft schedule was optimized. The results show that austenitic hot rolling of ultra thin strip in the single-belt process can be carried out like the conventional hot rolling for low carbon steels. With consideration of roll life the maximal roll surface temperature has a large influence on the establishment of the draft schedule for hot rolling of ultra thin strips.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.