Abstract
The widespread use of aerated concrete in construction has led to the emergence of many types and compositions. However, additional research should fill theoretical gaps in the phenomenon of gas release during the formation of the structure of aerated concrete. Based on theoretical analysis and experimental studies, the article proposes a mathematical model of the swelling process based on the physicochemical laws of convection and molecular diffusion of hydrogen from a mixture and the conditions of swelling, precipitation, and stabilization of the mixture. An improved method for the manufacture of aerated concrete is proposed, which consists of introducing cement pre-hydrated for 20–30 min into the composition of the aerated concrete mixture and providing improved gas-holding capacity and increased swelling of the mixture, reducing the average density of aerated concrete up to 29% and improving heat-shielding properties up to 31%. At the same time, the small dynamics of a decrease in the strength properties of aerated concrete were observed, which is confirmed by an increased structural quality factor (CSQ) of up to 13%. As a result, aerated concrete has been obtained that meets the requirements of environmental friendliness and has improved mechanical and physical characteristics. Economic efficiency is to reduce the cost of production of aerated concrete and construction in general by about 15%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.