Abstract
This paper investigates the material removal rate (MRR) in electro discharge micromachining (micro-EDM) of zirconia. Experimental investigation is carried out with 800 μm diameter tungsten electrode with two varying parameters rotational speed and gap voltage. The MRR data are analyzed and an empirical model is developed using Design Expert software. The optimum parameters for maximum MRR are found to be 375 rpm rotational speed and 80 V gap voltage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.