Abstract
Material properties required for the modelling of biscuit cracking (known in trade as checking) have been experimentally determined for semi-sweet (‘rich tea’) biscuits. Biscuits were prepared with several different fat concentrations, and studied at different moisture contents. Moisture diffusion coefficients were determined from moisture uptake plots obtained when biscuits were subjected to step changes in humidity. At relatively low moisture contents the diffusion coefficient increased with increasing moisture. However, this increase levelled off beyond a moisture content of about 6%, independent of fat content. Hygroscopic expansion coefficients were determined from the slope of strain vs. moisture content data. The expansion of the biscuit with moisture uptake was measured using digital speckle pattern interferometry (DSPI) following the application of step changes in humidity. Mechanical properties such as fracture stress, fracture strain and bending modulus were measured using 3-point bending. All showed considerable dependence on moisture content over a range of 4–12%. The knowledge of these material properties was used as an input to a semi-coupled diffusion stress finite element analysis (FEA). There was a good agreement between experimental results and finite element predictions for equilibrated biscuits subjected to changes in external humidity.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
