Abstract
Material flow and intermixing during dissimilar friction stir spot welding and friction stir seam welding are investigated. During friction stir spot welding, a ribbon of contiguous dissimilar lamellae is produced during each rotation of the tool and the number of intermingled lamellae contained in the intermixed region is determined by the tool rotational speed setting and the dwell time applied. When the rotating tool moves across the component, the ribbon of dissimilar contiguous lamellae continues to be produced and the linear distance in the traversing direction between dissimilar lamellae corresponds with the pitch distance [the travel speed (mm s−1) divided by the tool rotational speed (Hz)]. The material flow pattern produced when a threaded tool moves across a component is therefore a variant of that produced during the touch down period when the rotating tool is held stationary. It is suggested that the onion ring structures observed in similar and dissimilar friction stir seam welds made using threaded tools are produced by material incorporation from the locations beneath the tool shoulder and the bottom of the rotating pin and the creation of a helical vertical rotational flow within the intermixed region formed beside the periphery of the rotating pin.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
