Abstract
Purpose . Justification of the material and heat treatment method of aluminum alloy for the manufacturing of parts, type «plate» based on the results of microstructure and mechanical properties research; development of technological process of blanks operation of AK6 aluminum alloy . Methodology . Powdered alloy based on aluminum type AK6 was the research material. Finished forgings with the size 2520 × 1520 × 65 mm were obtained as a result of the preparation and forging of the blanks. After mechanical treatment of the blanks they were exposed to thermal processing and milling. Structure of the metal was examined under light microscope MIM-8M. Brinell hardness was used as the strength alloy characteristic. Findings . Influence analysis of alloy elements on the structure of deformable aluminum alloys was carried out. Research of influence of heat treatment modes on structure and properties of the AK6 alloy were performed. The improved technological process, which made it possible to obtain the item with the improved structure and properties and lower costs is offered. Originality . The samples of AK6 powdered alloy on fire resistance were tested. It is established that under heating of an example in the oxidative flame, it does not ignite to a temperature of 705 ° C. The cause of high fire resistance of AK6 alloy samples was found, it is connected with the presence in the material the evenly distributed, small oxide inclusions and amorphous oxide film on the surface. Practical value . Hard conditions of work (corrosion in marine and industrial atmosphere, static and shock loads, cyclic temperature) allow the use of the item in various designs.
Highlights
Застосування сплавів на основі алюмінію в промисловості значною мірою обмежується складнощами при їх обробленні
Justification of the material and heat treatment method of aluminum alloy for the manufacturing of parts, type «plate» based on the results of microstructure and mechanical properties research; development of technological process of blanks operation of AK6 aluminum alloy
Research of influence of heat treatment modes on structure and properties of the AK6 alloy were performed
Summary
Застосування сплавів на основі алюмінію в промисловості значною мірою обмежується складнощами при їх обробленні. Обґрунтування використання порошкового матеріалу та способу його термічної обробки для виготовлення заготовок з алюмінієвого сплаву АК6. Мікроструктура сплаву після кування без термічної обробки наведена на рис. 1. Мікроструктура литого сплаву АК6 після кування. Мікроструктурними дослідженнями визначено, що структура сплаву АК6 після термічної обробки
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Science and Transport Progress. Bulletin of Dnipropetrovsk National University of Railway Transport
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.