Abstract
Weapons are special systems, which have high demand in terms of reliability, safety and durability especially in the case of automatic weapons. The most stressed parts of weapons are barrels, breech, locking elements etc. This paper si focused on the failure of locking element, which is used for set the breech baffle and for locking of the breech. From the structural point of view the locking element is highly dynamically stressed component. During the shooting cycles are the shocks transferred into these components, therefore specified material requirements of the locking element are needed. The material of locking element must be modified to hard surface with tough core with thickness corresponding to the size and frequency of shocks to prevent the fatigue failure. The manufacturing documentation wasn't available, therefore the chemical analysis was performed using the GDOES/Bulk method. The results were compared with material standards to determine the Czech steel equivalent. The damaged locking element was metallographically tested, the surface and microhardness testing was performed by Vickers method. The fracture surface morphology was using the light and electron microscopy (SEM) observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.