Match of the Bimaxillary Basal Bone Arches and Its Variations among Individuals.

Abstract

Introduction This study is aimed at illustrating the bimaxillary basal bone contours, to clarify the match of the basal bone arches of the upper and lower, especially the posterior segments, including the second molar and retromolar region. Methods Based on 100 cone-beam computed tomography (CBCT) images (50 males and 50 females), we obtained 100 pairs of basal bone arches, which were the horizontal inner cortex contours passing the furcation of the first molar paralleled to the lower occlusal plane. The Generalized Procrustes Analysis (GPA) was applied to depict average contours and calculate the ratio and difference width of both upper and lower dental arches in different positions. Variations of the basal bone morphology among individuals were revealed using Principal Component Analysis (PCA). Results The width discrepancy occurred at 7-7 segment (male: upper 65.62 mm and lower 68.81 mm and female: upper 62.98 mm and lower 68.38 mm) and the retromolar region (male: upper 64.67 mm and lower 71.96 mm and female: upper 62.34 mm and lower 71.44 mm). The ratio (p = 0.006) and difference value (p = 0.009) of 7-7 segment and the ratio of retromolar region (p = 0.044) differed in genders. Setting 2 mm overjet, the upper basal bone arch was wider than the lower by approximate 2 mm on both sides, except the second molar and retromolar region. According to PCA, the variation of basal bone arches appeared mainly at terminal segments. Conclusions For both male and female, the bimaxillary basal bone matched except terminal segments. Mismatch of female bimaxillary posterior basal bone was more pronounced than male. The basal bone arches of male were wider and longer than that of female.