MASSIVE USE OF BERM RELOCATION AND SURFWASHING DURING THE 2006 JYEH OIL SPILL (LEBANON): THE ACCURATE RESPONSE FOR BEACHES CLEANUP

Abstract

ABSTRACT Following the bombardment of the Jyeh power station in Lebanon on July 16 2006, about 10 to 15000 tons of heavy fuel oil drifted 150 km northward all the way to the Syrian border. Because of the continuing war, the cleanup operations could not start until early September. The response consisted of conceptually dividing the coast line into several sectors managed by various operators; from Jyeh to Beyrouth, a 34.5 km stretch of shoreline, the treatment of beaches was assigned to the lebanese N.G.O “Bahr Loubnan’. In this area, 5.3 km of sandy and gravel beaches appeared to be heavily oiled on a width that seldomly exceeded 10 m. Oil was found buried down to a depth of 1.8 m at several locations. Additionnally oil was also found sunken in shallow waters in the breaker zones of numerous beaches. In order to minimize sediment removal and production of oily waste to be treated, it was decided to operate massive treatmenN in situ. After manual recovery of stranded oil, about 12,000 m of sediment including 1,000 m of cobbles have been relocated in the surf zone. Despite the lack of tides and of the generally calm weather conditions, surfwashing was very efficient due mainly to the fact that, in non tidal conditions, sediments are continuously reworked by wave açtion which operates at the same level on the beaches. Only 540 m of heavily oiled sand, was removed from beaches and submitted for further treatment. The lack of appropriate sorbents material in Lebanon to capture the floating oil released by surfwahing was also a challenge. This was addressed by using locally Nmanufactured sorbents, which proved to be very efficient and 60 m of sorbent soaked with oil were produced during the cleanup.