Abstract
Dynamically vulcanized thermoplastic elastomeric blends of nitrile rubber (NBR)/poly(styrene-co-acrylonitrile) (SAN) were mapped by tapping mode atomic force microscopy (TMAFM) and transmission electron microscopy (TEM). The morphology changes with the blend ratio and dynamic vulcanization. Roughness and surface analysis were used to study the effect of dynamic vulcanization and mixing sequence on the surface texture of the thermoplastic elastomeric blends. Surface geometry was quantified by power spectral density (PSD) and fractal analysis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
