Abstract
An enhanced Vacuum Assisted Resin Transfer Molding (VARTM) process was studied for the manufacturing and characterization of bipolar plate with textile reinforced polymer composites. Rapid qualitative evaluation and quantitative characterization were conducted respectively to achieve an optimal manufacturing process design. The influence of process variables including pre-compaction cycle, post-filling time, curing pressure, etc., on the geometrical and mechanical properties of the textile reinforced polymer composites were investigated. The empirical optimized process design was then adapted for manufacturing of bipolar plate. The electrical properties of the bipolar plate were characterized by measuring its bulk (in-plane) conductivity according to the conventional four probe method. The influence of process conditions, carbon fabric design and nanofillers on the electrical properties of the bipolar plate were considered. The results show that the bipolar plate has a flexural strength in the range of 166.6–188.3MPa, which is a great improvement in comparison with the one based on highly filled or cut fibres reinforced polymer composites. However, the maximum bulk conductivity achieved is limited at 5902Sm−1 in this study, suggesting that further development effort is required for bipolar plate manufactured by textile reinforced polymer composites.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
