Abstract
AbstractA stable experimental die drawing process has been operated for poly(oxymethylene) over a range of temperature. Rods possessing room‐temperature Young's moduli up to 23 GPa were produced using a homopolymer grade, the values obtained from a copolymer being somewhat lower. This compares favorably with the best modulus achieved by hydrostatic extrusion but is rather lower than that produced by conventional drawing; reasons for this are discussed. A stable die drawing process has also been operated for glass fiber‐reinforced poly(oxymethylene), but extensive macroscopic void formation occurred in the products under all conditions, reducing their potential for practical application.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have