Abstract
This paper reports a simple and effective ultrasonic embossing method which enables the rapid fabrication of dual-side surface-relief plastic diffusers with various cross angles. Metallic master molds bearing microstructures are fabricated using a tungsten carbide turning machine. A 1500-Watt ultrasonic vibrator with an output frequency of 20 kHz was used to replicate the microstructure onto 1 mm thick PMMA and PET films in the experiments. During ultrasonic embossing, the ultrasonic energy is converted into heat through intermolecular friction at the master mold/plastic plate interface due to asperities to melt the thermoplastic at the interface and thereby to replicate the microstructure. Under the proper processing conditions, high-performance dual-sided plastic diffusers of various cross-angles can be successfully fabricated. The proposed method shows great potential for fast fabrication of micro-optical components due to its simplicity and versatility.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
