Abstract
Much work has been done to find commercially efficient applications for metal foams produced using the powder metallurgical route. Most of these efforts have not been successful, because foam quality could not be reproduced reliably and production methods were too inefficient. This article describes the conditions under which aluminum foam sandwich parts may be put into series production in an economical way.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
