Mantle convection and early crustal evolution

Abstract

The existence of peridotitic komatiites in the Archaean suggests that the Archaean mantle was significantly hotter than the modern mantle. This evidence is contradicted by estimates of Archaean continental geothermal gradients, based on the pressure and temperature recorded in metamorphic rocks, which suggest that there is no marked difference between Archaean and modern continental geothermal gradients. Numerical modelling shows that small changes in the mantle temperature can have an important influence on convection. If the average temperature of the upper mantle is increased by 200°C, convection within the mantle becomes chaotic and an upper mantle partial melt zone encircles the globe. The crust formed during this period will be komatiitic in composition but will be unstable and will be mixed back into the mantle by subduction. Later, when the mantle temperature falls to 100°C above its present level, the upper mantle partial melt zone contracts away from subduction areas. It is suggested that the first primitive felsic magmas were generated at subduction zones. The appearance of these magmas at ∼3.8 Ga permitted the formation of buoyant continents and eventually led to crustal thickening. As a consequence of this thickening the proto-continents, consisting of a bimodal suite of basalts and sodic granodiorites, contained two types of latent energy: (1) radioactive energy held in elements such as Th, K and U; and (2) potential energy resulting from the elevation of the continents above sea level. The potential energy of the continents led to sedimentation. The increase in the rate of sedimentation during the Archaean resulted from increased crustal buoyancy. At the same time heat released by radioactive elements in the deep crust built up under the insulating blanket of the upper crust. This caused a major metamorphic, metasomatic and crustal melting event which produced the potassic granites of the late Archaean. Once the radioactive elements had been removed from the lower crust, that region of the continent become tectonically stable. The Proterozoic shelf sediments were deposited at the margins of these stable cratons. Convection models of the Archaean mantle show hot diapirs rising from the boundary layer above the core—mantle interface. We suggest that these diapirs began to melt at a depth of ∼ 450 km, giving rise to komatiitic magmas. This model requires the average temperature of the Archaean upper mantle to be ∼ 100°C above that of the modern mantle. The similarity between Archaean and modern continental geothermal gradients can be explained if Archaean continents formed above subduction zones. Raising the temperature of the Archaean mantle by 100°C (1) halves the thickness of the oceanic lithosphere, (2) increases the oceanic geothermal gradient at the mid-point of a convection cell, (3) decreases the viscosity of the mantle by at least an order of magnitude. The combination of these effects produces a marked decrease in the strength of the Archaean lithosphere and mantle. Thus the form of Archaean tectonics can be expected to have been very different from modern tectonics.