Manipulation of Band Structure and Interstitial Defects for Improving Thermoelectric SnTe

Abstract

AbstractMany efforts are recently devoted on improving thermoelectric SnTe as an environment—friendly alternative to conventional PbTe and successful approaches include valence band convergence, nanostructuring, and substantial/interstitial defects. Among these strategies, alloying SnTe with MnTe enables the most effective reduction in the valence band offset (between L and Σ) for a convergence due to its high solubility of ≈15%, yet there is no indication that the solubility of MnTe is high enough for fully optimizing the valence band structure and thus for maximizing the electronic performance. Here, a strategy is shown to increase the MnTe solubility up to ≈25% by alloying with 5% GeTe, which successfully locates the composition (20% MnTe) to optimize the valence band structure by converging a more degenerated Λ (as compared with band L) and Σ valence bands. Through a further alloying with Cu2Te, the resultant Cu‐interstitial defects enable a sufficient reduction in lattice thermal conductivity to its amorphous limit (0.4 W m−1 K−1). These electronic and thermal effects successfully realize a record‐high thermoelectric figure of merit, zT of 1.8, strongly competing with that of PbTe. This work demonstrates the validity of band manipulation and interstitial defects for realizing extraordinary thermoelectric performance in SnTe.