Management of Liquid Organic Waste from Palm Oil Plant and Compost Cow to the Growth and Production of Sweet Corn (Zea mays saccharata Sturt)

Abstract

The growth and production of sweet corn (Zea mays saccharata Sturt) are strongly influenced by good genetics and environmental factors, including how to cultivate the soil so that the availability of nutrients is quite balanced. The long-term goal of this research is to determine the effectiveness of a combination of palm oil mill effluent (LCPKS) and cow dung waste (LKTS) with EM4 bio-activator applied to sweet corn (Zea mays saccharata Sturt).
 This study used a factorial randomized block design (RBD) consisting of 2 factors with 12 treatment combinations and 3 replications to obtain 36 research plots. The factors studied are the formulation factor of a mixture of palm oil mill effluent with cow dung waste, which is denoted by (A) consisting of A1 = 70% palm oil mill waste and 30% cow dung, A2 = 50% effluent palm oil mill and 50% cow dung waste, A3 = 30% palm oil mill waste and 70% cow dung waste. The dose factor with the symbol (D) consists of, D0 = control, D1 = 1.5 kg per plot, D2 = 3 kg per plot, D3 = 4.5 kg per plot.
 The parameters observed were plant height (cm), biomass samples (grams), sample production (grams) and plot production (kg). The results showed that different waste mix formulations and administration of different doses did not significantly influence plant height parameters because compost maturity must be assessed by measuring two or more compost parameters to prevent phytotoxicity. Therefore, quality assurance must be carried out on compost to determine the factors that cause phytotoxicity and also research must be intensified in determining lines that will be able to degrade waste faster, more efficiently and also produce non-toxic compost that mixes the soil produced in plant growth. In addition, care must be taken in selecting raw materials for composting. The results showed that the mixed waste formulations significantly affected the biomass of the sample, where the highest average was obtained in processing A3 (30% of palm oil mill waste and 70% of cow dung waste. The research results also showed that dosing had a very significant effect on biomass parameter sample, sample production and plot production where the highest average is in the D3 treatment (4.5 kg per plot).