Abstract
A make arc has been investigated using a new testing apparatus. This apparatus which includes a piezo-translator, enables controlled bouncing to be studied at make under mechanical conditions similar to those encountered in automotive relays. Material transfer and welding tendency of silver, silver alloys and silver metal oxide contact materials have been studied under inductive, resistive and lamp loads at 14 V dc and 10-70 A. With all loads, anode to cathode material transfer has been observed. AgCdO, Ag and AgNi under lamp and resistive loads show the highest material transfer, as opposed to non doped and doped AgSnO/sub 2/ under inductive loads. This well known transfer is due to the anodic arc, which occurs during bounces when the gap between the contacts is shorter than /spl sim/5 /spl mu/m, at the beginning and the end of the bounce. We have demonstrated that welding occurs at the beginning of the bounce, i.e. when the contacts begin to separate under arc, and not when the contacts close under arc at the end of the bounce. It was found that welding occurs mainly with Ag, AgCdO, AgZnO, AgFeRe, and AgFeO/sub x/ contact materials, and under high inrush current produced by lamp loads.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Components and Packaging Technologies
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
