Abstract
Maintaining and Troubleshooting Your 3D Printer by Charles Bell is your guide to keeping your 3D printer running through preventive maintenance, repair, and diagnosing and solving problems in 3D printing. If youve bought or built a 3D printer such as a MakerBot only to be confounded by jagged edges, corner lift, top layers that arent solid, or any of a myriad of other problems that plague 3D printer enthusiasts, then here is the book to help you get past all that and recapture the joy of creative fabrication. The book also includes valuable tips for builders and those who want to modify their printers to get the most out of their investment. Good fabrication begins with calibration. Aligning the print bed to support deposition of medium in three dimensions is critical. Even off-the-shelf machines that are pre-built must be aligned and periodically realigned throughout their life cycle. Maintaining and Troubleshooting Your 3D Printer helps you achieve and hold proper alignment. Maintaining and Troubleshooting Your 3D Printer also helps with software and hardware troubleshooting. Youll learn to diagnose and solve firmware calibration problems, filament and feed problems, chassis issues, and more. Finally there are regular maintenance and enhancements. Youve invested significantly in your 3D printer. Protect that investment using the guidance in this book. Learn to clean and lubricate your printer, to maintain the chassis, and know when realignment of the print bed is needed. Learn ways to master your craft and improve the quality of your prints through such things as post-print finishing and filament management. Dont let the challenges of 3D printing stand in the way of creativity. Maintaining and Troubleshooting Your 3D Printer by Charles Bell helps you conquer the challenges and get the most benefit from your expensive investment in personal fabrication. What youll learn Achieve proper calibration through aligning your print bed in three dimensions Choose the best filament and media to use in different types of projects Diagnose software issues such as problem STL files and calibration errors in firmware Extend the life and accuracy of your device by keeping up with regular maintenance Contribute your own, successful 3D models back to the community Enhance quality through filament management, the addition of hot ends, and more Who this book is for Maintaining and Troubleshooting Your 3D Printer by Charles Bell is aimed at owners of Maker Bot and similar 3D printing devices. If you own such a machine, and especially if youve ever been frustrated in getting it to perform and deliver on a design that youve created, then this book has been written with you in mind. Maintaining and Troubleshooting Your 3D Printer is written to help you troubleshoot and diagnose the many problems commonly encountered in the field of personal fabrication.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.