Abstract
A magnetoelectric (ME) bending-mode structure based on Metglas/Pb(Zr,Ti)O(3) fiber laminates has been studied. This bending mode had a fundamental resonance (FBR) of about 210 Hz, which was much lower than that of the longitudinal mode. Near the FBR, the ME voltage coefficient was about 400 V/cm·Oe. Magnetic sensors based on this bending mode had an equivalent magnetic noise floor of ≤ 0.3 pT/√Hz at f = 210 Hz.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.