Magnetic signature reproduction of ferromagnetic ships at arbitrary geographical position, direction and depth using a multi-dipole model

Abstract

The reproduction of magnetic signatures is an important issue concerning the safety of ship traffic, as well as the identification and classification of vessels. Moreover, military applications of magnetic signatures and their reproduction refer to the activation or protection against activation of magnetic naval mines. Previous works on this subject focused on recording and replicating the signatures under the same conditions as those under which they were measured, e.g., on the same ship courses. In this article, much greater capabilities of the multi-dipole model are presented, including simultaneous identification of permanent and induced magnetism. Determining the dipole values using the data from cardinal directions gives the possibility of determining the magnetic field density at any trajectory (position), direction, or depth, with further reconstruction of the entire magnetic field on the basis of residual measurements. For the purpose of this article, a numerical test model of a corvette-type ship has been modelled in Opera simulation software for different geographical positions. The synthetic data from the simulator served as the data source for determining the parameters of the multi-dipole model and the reference data for the verification of the signatures reconstructed for other positions, directions, and depths than those used to determine the model parameters. To determine all permanent magnetization components, data sets were used for two different values of the external magnetic field vertical component. Finally, as a culmination of the demonstration of model universality, the entire magnetic field around the ship was reproduced for different control points on Earth, and for different courses and depths. Investigating the possibility of reconstructing the magnetic signature at a different geographic location than the place where the measurement was made for model synthesis is the main original issue considered in this paper.