Abstract
Grinding operations are sometimes replaced with hard turning or milling cycles. Mechanism of chip separation during grinding and the corresponding surface integrity remarkably differs from hard turning or milling. For this reason, this paper deals with application of Barkhausen noise for evaluation of surface anisotropy after hard milling. Experiments were carried out on bearing steel 100CrMn6 hardened on 45, 55, 62 HRC and one series without heat treatment. The analysis contains comparison of RMS values for the different hardness and tool wear after hard milling and also discusses the specific mechanism of BW motion in the case of cyclic magnetization.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
