Abstract
Thin, single-crystal films of Ni, Fe, Ni-Fe and Ni-Co have been grown by vacuum deposition onto heated rock salt. The cubic crystalline anisotropy constant, K <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">1</inf> , of these films has been measured at room temperature by a torque method. In the case of the Ni-Fe alloys, K <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">1</inf> was found to be the same for thin films as for bulk materials of the same composition. The measured anisotropy in the Ni-Co films differs quantitatively but has the same qualitative variation with composition as is reported for bulk crystals. The results of one magnetic annealing experiment on a 75% Ni - 25% Fe film lends support to the short-range ordering model of uniaxial anisotropy in alloys. Pure nickel films exhibit a pronounced uniaxial anisotropy superimposed on the crystalline anisotropy. This uniaxial term disappears after the film is removed from the substrate, indicating that its origin is in an anisotropic stress in the deposited film.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
