Abstract
Volcano deformation is usually measured using satellite geodetic techniques including interferometric synthetic aperture radar (InSAR), campaign GPS, and continuous GPS. Differences in the spatial and temporal sampling of each system mean that most appropriate inversion scheme to determine the source parameters from each data set is different. Most studies either compare results from independent inversions or subsample the data sets to the lowest common factor. It is unclear whether differences in the solution reflect differences in source behavior, differences in measurement bias, or differences in inversion technique. Here we develop a single inversion procedure that captures the benefits of each system, especially the daily sampling of continuous GPS and the high spatial resolution of InSAR. Okmok Volcano, Alaska, is an ideal target for such a test because a long series (<15 years) of InSAR and continuous GPS measurement exists and the source is almost continuously active and in a stable location.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.