Abstract
Force–displacement responses and failure behaviour of connections using flow-drill screws to join aluminium sheets were investigated under various quasi-static loading conditions. This included single connector tests under tensile, shear and combined tensile and shear loadings, using cross test coupons in a new test set-up, and peeling and single lap-joint tests. The strength of the connection increased with the amount of shear loading, while the ductility decreased. No effect of the anisotropy of the sheets on the behaviour in the single connector tests was found. Axial crushing tests of aluminium single-hat sections joined with flow-drill screws were also performed. Two connection failure modes not observed during the single connector test were found in these tests. For comparison, equivalent single connector and component tests were carried out for self-piercing rivet connections. Similar trends with respect to the ductility, maximum force and shape of force–displacement curves were observed for the two connections, but the local failure modes were different.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
