Abstract
The measurement of chemical concentration profiles in pore water is a starting point for the analysis of biogeochemical processes in waterlogged peat soils. Concentration patterns may be obscured when macroporosity causes preferential flow in column experiments and when pore water is retrieved from the peat by suction. To investigate the magnitude of such effects, we used LiBr as a tracer in peat columns at outflow rates of 0, 2–3, and 8 mm d−1. The results were compared with modeled advective-diffusive migration rates. Twenty to fifty percent of the tracer was recovered from depths at which the tracer would have been absent if preferential flow had not occurred. At the high flow rate, the preferential flow was stronger, and the retrieved pore-water was probably in disequilibrium with the matrix. When pore water was retrieved by suction, linear concentration gradients decreased by about 30% through the recovery of water from different depths, and the quality of fitted linear gradients decreased from R2 = 0.99 to R2 = 0.82. When flow rates are low (<3 mm d−1) and pore water concentration values from samplers are aggregated or regressed, the obtained concentration profiles seem to represent the vertical distribution of chemical species reasonably well. The use and interpretation of pore water profiles in peat soils is problematic if flow rates are higher and if vertical gradients are based on individual or few data points that have been obtained by suction samplers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.