Abstract
The main goal of this work is to optimize the quadratic mean roughness Rq and the machining time T in ball end milling of the Titanium alloy Ti-6Al-4V. The Taguchi method was applied in this research in order to analyze the impact of each milling parameter on the surface roughness and the machining time. In fact, an orthogonal array L9, a signal to noise ratio S/N analysis and Pareto ANOVA were used to select the optimum levels combination of the milling parameters and to investigate the impact of each milling parameters on the machining time and surface roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
