Abstract
Inconel 718 is a nickel-based superalloy with exceptional mechanical qualities, including high tensile and impact strength, as well as good oxidation and corrosion resistance. EDM is widely used to cut hard materials of this type by common parameters affecting spark, current, duty cycle etc, whereas MRR, SR can be greatly improved by using sufficient fluid properties of the dielectric. Incorporation of alumina nanoparticles with deionized water may improve machining performance, with no prior research on machining characteristics of Inconel 718 using alumina nanofluid in EDM. The machinability of Inconel 718 via the electrical discharge machining process, as well as the performance of alumina nanofluid as a dielectric medium, have been evaluated using deionized water with a concentration of 0.5%. In this study, based on the effect of various input parameters such as and on the MRR, TWR and SR, and the RSM has been used to conduct the experiments. A maximum MRR of 0.048 g min−1, a TWR of 0.00632 g min−1 and an SR of 3.271 μm are achieved. Overall, the use of alumina nanofluid can improve machining performance in EDM, due to the reduction of abnormalities such as crack formation and molten metal debris in the machined surface of Inconel 718.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have