Abstract
The ever-increasing demand for cost-effective machining of Ni (Nickel) based superalloys has made it necessary to explore nanocomposite coatings as a potential surface engineering solution. The present study aims to investigate the variation in machining performance of new-generation hard wear-resistant coatings in milling of IN 718 (Inconel 718), IN 625 (Inconel 625), and IN 617 (Inconel 617). TiAlSiN and CrAlSiN coatings were grown in-house over tungsten carbide (WC) milling inserts through the cathodic-arc PVD route. The TiAlSiN coating improved the tool life by 80 % and 60 % in the case of IN 718 and IN 625, respectively. However, in the case of IN 617, the TiAlSiN-coated tool could not even reach the uncoated tool life. The CrAlSiN coating, on the other hand, improved the tool life by more than 200 % in the milling of IN 617. Tool-chipping was the dominant failure mode among all observed, which included flank wear and workpiece adhesion. The repeated adhesion and removal of the workpiece layer from the tool surface was a major cause of tool failure. The coating layer delayed the initiation of the chipping and prolonged the flank-wear-dominated machining time, resulting in improved tool life. The wear resistance of coatings in machining different workpiece materials was greatly influenced by the relative affinity of constituting elements of workpieces for employed coatings. The machining chips exhibited shear bands and saw-tooth (serrated/segmented) morphology in almost all cases. The degree of segmentation showed a direct correlation with tool life. The present work helps identify the optimum coating and machining conditions for three different grades of Ni-based superalloys. Additionally, the underlying mechanisms were analyzed and discussed with scientific observations.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.