Abstract
For higher tool life of cutting inserts cryogenic treatment is considered as the most prominent method but no substantial researches have been found concerning the impact of cryogenic treatment on cermet inserts especially in hard turning. Therefore, in the present experimental investigation, the comparative assessment of various responses such as cutting force, flank wear, crater wear, chip morphology and surface roughness were carried out during machining of hardened steel with both untreated and cryo treated cermet inserts hard turning under dry cutting condition. Lastly, the input variables were optimized using Response surface methodology (RSM) to evaluate the tool life for the economic analysis. The experimental result demonstrated that the uncoated deep cryo treated with tempered cermet insert delivered better results in comparison to other cermet inserts. According to cost analysis, uncoated and deep cryo treated with tempered cermet insert was found to be the most economical among other cermet inserts at the optimum cutting condition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
