Abstract
Tungsten/carbon (W/C) multilayer thin films with a nominal d spacing varying from 2.5 to 14 nm were prepared by magnetron sputtering technique. The thicknesses of the W and C layers were varied from 0.5 to 12 nm. The multilayers were subjected to isochronal anneals in a quartz tube furnace in the range of 300 to 1000 C under high purity Ar flow conditions. X-ray diffraction, Raman scattering and Auger depth profiling were used to characterize the structure of the as-prepared and annealed films. It is found that an overcoat layer of silicon nitride (30-50 nm) prevents the multilayers from oxidation during the 1 hr heat treatment at temperatures as high as 1000 C in Ar flow. In all studied W/C multilayers, the carbon layers are amorphous (up to 12 nm). The tungsten layers are also amorphous when their thicknesses are less than 5 nm. Tungsten layers thicker than 5 nm show crystalline W peaks in addition to the amorphous W feature. Annealing of samples with a silicon nitride protective layer results in several structural changes which depend on annealing temperature, d spacing, the as-deposited W layer structure and the layer thickness ratio of W to C. For W layer thicker than C layer and W layer thickness > 4 nm and/or C layer thickness < 1 nm, the multilayers show the initial crystal formation of microcrystalline W2C occurring at C-W interfaces (that interface in which C was deposited on W) after 600 C anneal, followed by a second crystallization of a-W or a-W and WC at W-C interfaces (W was deposited on C) at the annealing temperature of 900 C. They reveal a relatively small (< 5 %) or essentially no layer expansion. For those multilayers having thin W layers (2 nm) and the same or thicker C layer thicknesses, the initial crystallization takes place at both W-C and C-W interfaces at 900 C or higher. The crystal formed is a-W or a-W and WC. The layer pair period of the multilayers in this group increases monotonically with increasing annealing temperature. Expansion is up to 16 % of the original d spacing and occurs in both W and C layers at approximately equal rates. The expansion in all multilayers is interpreted to be associated mainly with the structural ordering processes in the amorphous W and C layers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.