Abstract
Abstract A femtosecond laser is a type of ultrashort-pulse laser. Femtosecond laser irradiation induces high-pressure plasma and shock waves at the surface of a target. Under some irradiation conditions, such shock waves are enough to deform the target plastically. Laser peen forming is a type of sheet metal forming using this deformation by shock waves. The author adopted laser peen forming using femtosecond laser for thin-sheet-metal bending. Generally, shock waves induced in air are much smaller than those induced in water, and thus; are unfavorable for plastic deformation. However, the shock waves induced by a femtosecond laser were enough to bend a thin sheet metal even in air. Elastic pre-bending was adopted during the process. Bending angle was increased by applying pre-bending. The effects of laser irradiation conditions on bending efficiency were investigated. The large spot diameter and high fluence improved bending efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of the Japan Society for Technology of Plasticity
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.