Low-temperature synthesis and characterization of anatase TiO2 powders from inorganic precursors

Abstract

Nowadays, it is a great challenge to synthesize crystalline TiO(2) using low-temperature methods without a calcination step. In our study, the anatase TiO(2) powders were synthesized using titanium tetrachloride (TiCl(4)) as a precursor via the sol-gel method at low-temperature preparation conditions. Perchloric acid and nitric acid were used as peptizing mediators. The powders were obtained with consequent drying of the sols via evaporation of the solvent. The remaining acid in the powders prevented the aggregation of particles in the aqueous solution. The as-prepared catalysts were characterized by X-ray diffraction, thermal analysis, UV-Vis spectroscopy, BET surface area. The aggregate size of TiO(2) in the colloidal suspension solution was measured by dynamic light scattering. Material characteristics were correlated with photocatalytic activities of the prepared samples towards degradation of aqueous phenol solution under UVA radiation. Using HClO(4) instead of HNO(3) resulted in smaller colloidal particles of TiO(2) in the sol and in higher surface area of the powder, while the primary crystallite sizes for both types of powder were similar. The HClO(4)-based TiO(2) had approximately a 1.5 times higher catalytic activity than similar catalysts prepared by using HNO(3). Smaller aggregated colloidal particles, and consequently a larger surface area in HClO(4)-based powder, demonstrate the main reason for better photocatalytic activity compared to the HNO(3)-based powder.