Abstract
Galloping-based piezoelectric energy harvesting systems are being used to supply renewable electricity for low-power wireless sensor network nodes. In this paper, a W-shaped bluff body is proposed as the core component of a piezoelectric wind energy harvester. Experiments and simulations have shown that the W-shaped bluff body can improve harvesting efficiency at low wind speeds. For the W-shaped structure, the finite element simulation results indicate that the structure can help improve the aerodynamic performance to obtain high aerodynamic force. The experimental results demonstrate that compared with the traditional bluff bodies, the piezoelectric wind energy harvester with the W-shaped bluff body (WEHW) can generate higher output voltages and has a lower cut-in speed. When the length L is 30 mm and the rear groove angle β is 30°, the W-shaped structure can induce the best harvesting performance. When an external load resistance of 820 KΩ is connected and the wind speed is 5 m/s, the WEHW generates an average output power of 0.28 mW.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.