Abstract
Copper oxide particles of various sizes and constituent phases were used to form conductive circuits by means of photonic sintering. With the assistance of extremely low-energy-density xenon flash pulses (1.34 J/cm2), a mixture of nano/submicron copper oxide particles can be reduced in several seconds to form electrical conductive copper films or circuits exhibiting an average thickness of 6 μm without damaging the underlying polymeric substrate, which is quite unique compared to commercial nano-CuO inks whose sintered structure is usually 1 μm or less. A mixture of submicron/nano copper oxide particles with a weight ratio of 3:1 and increasing the fraction of Cu2O in the copper oxide both decrease the electrical resistivity of the reduced copper. Adding copper formate further improved the continuity of interconnects and, thereby, the electrical conductance. Exposure to three-pulse low-energy-density flashes yields an electrical resistivity of 64.6 μΩ·cm. This study not only shed the possibility to use heat-vulnerate polymers as substrate materials benefiting from extremely low-energy light sources, but also achieved photonic-sintered thick copper films through the adoption of submicron copper oxide particles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
