Abstract

The hydrogenation and competitive hydrogenation of anisole, phenol and 4-methoxyphenol was studied in the liquid phase over a Rh/silica catalyst at 323 K and 3 barg hydrogen pressure. The rate of conversion of the reactants to products gave an order of anisole ≫ phenol > 4-methoxyphenol with hydrogenation and hydrodeoxygenation products being produced. Anisole, the most reactive substrate, was rapidly converted to methoxycyclohexane, cyclohexane, cyclohexanone and cyclohexanol, while phenol was hydrogenated to cyclohexanone, cyclohexanol and cyclohexane. In both cases cyclohexanol was produced as a secondary product from cyclohexanone hydrogenation. The yield of cyclohexane, the hydrodeoxygenation (HDO) product was > 20% from both reactants and was formed as a primary product from the aromatic species. Hydrogenation of 4-methoxyphenol was selective to 4-methoxycyclohexanone with no alcohol formation, while the hydrogenolysis products revealed that the catalyst was more active for demethoxylation than dehydroxylation. A comparative strength of adsorption was determined from competitive hydrogenation and gave an order of anisole > phenol > 4-methoxyphenol. Competitive, pair hydrogenation inhibited HDO and stopped cyclohexane from being produced from phenol and 4-methoxyphenol, although it was still produced from anisole. An increased rate of hydrogenation for 4-methoxyphenol was observed for competitive reactions with phenol and anisole but not when all three reactants were present. In contrast to the pair reactions, when all three reactants were present HDO occurred with all aromatics producing cyclohexane. Replacing hydrogen with deuterium revealed an inverse kinetic isotope effect for ring hydrogenation of 4-methoxyphenol but not phenol or anisole, which both had a positive KIE.

Highlights

  • Hydrogenation and hydrodeoxygenation (HDO) of bio-oils is currently a significant research undertaking [1, 2] and a wide range of conditions and catalysts have been investigated [3]

  • The rate of conversion of the reactants to products gave an order of anisole ≫ phenol > 4-methoxyphenol with hydrogenation and hydrodeoxygenation products being produced

  • Anisole was converted to methoxycyclohexane, cyclohexane and cyclohexanone as primary products; cyclohexanone was only hydrogenated to cyclohexanol once all the anisole had been reacted, confirming a sequential route to cyclohexanol

Read more

Summary

Introduction

Hydrogenation and hydrodeoxygenation (HDO) of bio-oils is currently a significant research undertaking [1, 2] and a wide range of conditions and catalysts have been investigated [3]. Cyclohexanone, and subsequently cyclohexanol, were formed by demethylation (ArO–CH3 bond breaking) of anisole giving a phenolic surface intermediate (no phenol detected in solution) that is rapidly hydrogenated. The hydrogenation of phenol gave cyclohexanone and cyclohexanol, while cyclohexane was the hydrogenolysis product at 20% yield at 100% conversion.

Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.