Abstract
BaTiO3 (BTO) films have been deposited on SrTiO3 (STO) wafers by a rf-mode electron cyclotron resonance sputtering system. The substrate surface is pretreated in several ways before film deposition. The oxygen plasma irradiation is the best way of pretreating the substrate surface. Single-crystal BTO films with smooth surfaces are deposited on STO at temperatures ranging from 350 to 650 °C at total gas pressures ranging from 0.02 to 0.1 Pa. BTO films with (100) orientation are obtained at temperatures as low as 200 °C. The dielectric constant of films grown at 350 °C reaches 470 and that of films grown at 550 °C reaches 880.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.