Abstract
Bringing solid-state lithium batteries to market is a challenge; in part because their fabrication requires a technically difficult step of solid-electrolyte separator assembly, and because thus far, solid-state cells have only cycled under high pressure. Here, we address both these bottlenecks by assembling lithium-ion batteries based on the argyrodite Li6PS5Cl as the electrolyte using standard coating processes. Moreover, we upscaled to 10 cm2 pouch cells in a dry room by a double casting technique, thanks to the use of fluorine-free polyisobutene as the binder and nanosilicon and LiNi0.6Mn0.2Co0.2O2 (NMC622) respectively as the anode and cathode active materials. Electrode casting is shown to significantly improve the cycling stability when compared to the conventional pelletizing process. The all-coated pouch cells, cycled at a pressure as low as 1 MPa over 160 cycles, show a better capacity retention than the pelletized cells cycling under >100 MPa. The higher performance of the sheet-type cell is thought to originate in the better densification and homogeneity of the cell, attested by its low resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.