Abstract
This work discusses the design, finite element method modeling (FEM), fabrication and characterization of a silicon-based, catalytic micro calorimetric sensor. The sensing area is comprised of two titanium silicide (TiSi2) – polysilicon (poly-Si) resistive temperature sensors symmetrically positioned relative to a poly-Si heater on which an oxidation promoting catalyst is deposited. The resistive structures are located on a suspended, thereby, thermally isolating, low mechanical stress membrane and integrated into a glass flow channel. The micro-calorimetric sensor is applied for measuring propane and hydrogen concentrations in air.An approach to optimization of thermal and fluidic design of the microsensor is presented based on developed models: (i) a 3D thermo-electric analysis of the suspended heater and (ii) a 2D thermo-chemical analysis of the catalytic oxidation of propane in the flow channel. Influence of the design and material of the membrane on the power consumption and temperature distribution across the sensing area are analyzed. A relationship between the thermal design of the sensor, reaction conditions and its operation as a thermal actuator and sensor of reaction heats are discussed.Various thermo-electrical characterizations (electrical, infrared surface imaging and transient thermal response measurements) in the context of microcalorimetric sensing are performed. Microsensors with a 50μm×50μm sensing area consume ca. 12mW at an operational temperature of 350°C. Thermal imaging with an infrared camera indicates local heating with a temperature gradient across the active area estimated to be 4°Cμm−1 (at ca. 500°C). The heating and cooling times are found to be ca. 1 and 8ms, respectively. Temperature vs. power curves are determined for both stationary and constant flow conditions of various gases. Based on the experimental and modeling results we envision that these microsensors can be successfully used for calorimetric sensing and analysis of gaseous samples.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
