Abstract
An ion milling system was used to implant low energy nitrogen into an Si surface. The material composition and Si‒N bonding of the film after various annealing conditions were investigated using grazing angle backscattering and infrared transmission spectroscopy. The ratio of Si to N was about 1 in the as‐implanted films. After thermal annealing, the film composition changed and approached that of a stoichiometric nitride. Oxidation resistance of the film in wet and dry ambients was studied. Examination of the LOCOS profile revealed a marked decrease in the lateral oxidation as compared to the conventional process. The film exhibited insulating characteristics after 4 hr annealing at 900°C in nitrogen.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.