Abstract
The low dielectric loss polymer-ceramic composites with high density polyethylene (HDPE) as matrix and BaO-Nd2O3-TiO2(BNT) as filter for wireless temperature sensation were prepared by an extrusion processing technique. For 30vol % ceramic loaded HDPE, as the ambient temperature increases from 30 to 100 °C, the relative permittivity and loss tangent of the composite vary from 6.25 to 6.09 and from 0.004 to 0.011 respectively, and the temperature coefficient of relative permittivity is -370ppm/°C. By using this composite as the patch microstrip antenna substrate, a simple UHF RFID temperature sensor antenna is fabricated and measured. The experimental results show that a 2MHz/10°C frequency increment can be obtained at 900 MHz in the temperature range from 25 to 100°C.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.