Abstract
Gravity die casting (GC) and squeeze casting (SC) T4-treated Al–7.0Zn–2.5Mg–2.1Cu alloys were employed to investigate the microstructures, mechanical properties and low cycle fatigue (LCF) behavior. The results show that mechanical properties of SC specimens are significantly better than those of GC specimens due to less cast defects and smaller secondary dendrite arm spacing (SDAS). Excellent fatigue properties are obtained for the SC alloy compared with the GC alloy. GC and SC alloys both exhibit cyclic stabilization at low total strain amplitudes (less than 0.4%) and cyclic hardening at higher total strain amplitudes. The degree of cyclic hardening of SC samples is greater than that of GC samples. Fatigue cracks of GC samples dominantly initiate from shrinkage porosities and are easy to propagate along them, while the crack initiation sites for SC samples are slip bands, eutectic phases and inclusions at or near the free surface.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transactions of Nonferrous Metals Society of China
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
