Low-Cost Haptic Simulation Using Material Fracture.

Abstract

Medical simulation training is widely used to effectively train for invasive medical procedures such as peripheral nerve blocks. Traditionally, accurate haptic training relies on expensive cadavers, manikins, or advanced haptic robots. Proposed herein is a novel concept for haptic training called the low-cost haptic force needle insertion simulator (LCNIS), which uses material fracture inside disposable cartridges to accurately replicate the force of inserting a needle into tissue. Cadaver and material fracture experiments were performed to develop and determine the accuracy of the LCNIS. The material testing showed that polycarbonate had the highest maximum needle puncture force of the materials tested, 9.85 N, and that fluorinated ethylene propylene had the lowest maximum puncture force, 0.84 N. The cadaver results showed that the error between the three peak forces in a cadaver and a cadaver mimicking cartridge was 1.00 N, 0.01 N, and 1.54 N. The standard deviation of these peaks was 0.60 N, 0.55 N, and 0.41 N. This novel method of haptic simulation can easily be adapted to recreate any type of force and, therefore, could be utilized to train for a wide variety of medical procedures.