Low Cost Engine Management System With Two Degrees Freedom Air-Fuel Ratio Controller for a Small Displacement Port Fuel Injected SI Engine

Abstract

A two-degree freedom air fuel ratio controller (Model based feed forward transient plus closed loop Proportional-Integral-Derivative (PID) steady state controllers) developed for controlling the air fuel ratio of the charge in a small displacement (125 CC) SI engine is presented. The feed forward controller’s airflow and injector models were developed after conducting extensive experiments on the engine modified for the Port Fuel Injection (PFI) operation. A dynamic air fuel ratio model obtained (air fuel ratio changes measured using an UEGO sensor) by injecting the Pseudo Random Binary Signal (PRBS) signal in addition to base line fuel injection pulse, was used for designing the PID controller. Optimal PID gain values were identified using Nelfer-Mead optimization technique. The control algorithms were implemented and optimized using SIMULINK blocks that are run under dSPACE on the MicroAuto box hardware. The optimized control algorithms were ported on the specially designed, in-house built, low cost engine management system (EMS) developed around an 8-bit microcontroller. The spark timing was also controlled simultaneously for knock free operation. The two-degree freedom air fuel ratio controller could maintain the air fuel ratio under steady and transient conditions closely. High thermal efficiency and low HC & NOx emissions were achieved using the developed EMS. At higher speed elevated NOx emission was observed, due to the use of leaner mixture. The improvements are expected to be higher if a suitable smaller injector is used.