Abstract
We investigate power losses in back-contact back-junction monocrystalline thin-film silicon solar cells fabricated using the porous silicon layer transfer process. Our loss analysis combines two-dimensional finite element modeling and resistance network simulations. The input parameters of the finite element modeling are determined experimentally by measuring saturation current densities and sheet resistances on test samples prepared identically to the solar cells. Characteristic solar cell parameters such as short circuit current, open circuit voltage, fill factor, and efficiency of measured and network simulated current voltage characteristics investigated in this study match within an uncertainty of 5%. Free energy loss analysis serves as comparison of all losses in units of power per area at the maximum power point. The largest loss is bulk recombination due to a carrier lifetime of 2 μs in the epitaxial Si layer. Further significant losses result from recombination at the base contacts characterized by a diode saturation current density of 50 000 fA cm−2 as well as resistive losses due to lateral majority carrier current flows within the solar cell base and contact resistance losses.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
