Long-term wear effects on nanosilver release from commercially available food contact materials

Abstract

ABSTRACTPotential consumer exposure to nanoparticles (NPs) from nanoenabled food contact materials (FCMs) has been a driving force for migration studies of NPs from FCMs. Although NP migration from fresh, unused FCMs was not previously observed, conditions that result in significant changes to the surface of FCMs have not been investigated for NP migration into food. Therefore, a quantitative assessment of nanoparticle release from commercially available nanosilver-enabled FCMs was performed using an abrasion protocol to simulate cleaning, cutting, scraping and other stressful use conditions. Laser scanning confocal microscopy (LSCM) analysis showed a general increase in root mean square (RMS) roughness after FCM abrasion, and particle count (for particle sizes from 80 nm to 960 nm) at the surface was 4 orders of magnitude higher for the abraded FCMs. Migration was evaluated using both water and 3% (v/v, volume fraction) acetic acid as food simulants. Low concentrations of total Ag were detected in water simulants with a small portion (<10 ng dm−2) in the form of silver nanoparticles (AgNPs). Median particle diameter ranged from 39 nm to 50 nm with particle number concentrations on the order of 106 particles dm− 2. Total Ag migration into 3% (v/v) acetic acid was significantly higher than in water; however, 3% (v/v) acetic acid was not suitable for evaluation of NP release due to dissolution of AgNPs to Ag+ under acidic solution chemistries.